EasyManua.ls Logo

Stryker Power-PRO IT Cot - Removing a SMRT Pak from the cot

Stryker Power-PRO IT Cot
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IInnssttaalllliinngg tthhee ooppttiioonnaall hheeaadd eenndd ssttoorraaggee ffllaatt
WWAARRNNIINNGG -- Do not allow the head end storage flat (if equipped) to interfere with the operation of the retractable head
section, safety bar, or vehicle safety hook.
CCAAUUTTIIOONN -- Do not load the head end storage flat above the safe working load of 40 lb (18 kg).
To install the head end storage flat (Figure 24):
1. Install the VVeellccrroo® straps (A) near the pneumatic cylinder and around the cross tube (C) of the retractable head section.
2. Buckle the restraint straps (B) around the outer rails of the retractable head section.
FFiigguurree 2244 HHeeaadd eenndd ssttoorraaggee ffllaatt
IInnssttaalllliinngg aa SSMMRRTT PPaakk
The SSMMRRTT Pak is designed to be compatible with the PPoowweerr--PPRROO XT, PPoowweerr--PPRROO IT, and PPoowweerr--PPRROO TL cots.
To maximize available battery power, only use SSMMRRTT Paks that have been charged within the last 48 hours.
To install the SSMMRRTT Pak:
1. Align the tabs in the battery enclosure.
2. Push the SSMMRRTT Pak into the enclosure until the latch clicks into place.
The SSMMRRTT Pak can remain on the PPoowweerr--PPRROO cot between service calls for up to one week or until the cot battery LED
indicator flashes amber.
6516-209-001 Rev D.0 39 EN

Table of Contents

Related product manuals