Stryker Power-PRO IT Cot - Guidance and manufacturers declaration - electromagnetic immunity

RReeccoommmmeennddeedd sseeppaarraattiioonnss ddiissttaanncceess bbeettwweeeenn ppoorrttaabbllee aanndd mmoobbiillee RRFF ccoommmmuunniiccaattiioonnss eeqquuiippmmeenntt aanndd PPoowweerr--
PPRROO
115500 kkHHzz ttoo 8800 MMHHzz
DD==((11..22)) ((√√
PP ))
8800 MMHHzz ttoo 880000 MMHHzz
DD==((00..1188)) ((√√ PP ))
880000 MMHHzz ttoo 22..55 GGHHzz
DD==((00..3355)) ((√√ PP ))
0.01 0.12 0.018 0.035
0.1 0.38 0.57 0.11
1 1.2 0.18 0.35
10 3.8 0.57 1.1
100 12 1.8 3.5
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in watts (W) according to the transmitter manufacturer. Note 1: At 80 MHz and 800 MHz,
the separation distance for the higher frequency range applies. Note 2: These guidelines may not apply in all situations.
Electromagnetic propagation is affected by absorption and reflection from structures, objects, and people.
GGuuiiddaannccee aanndd mmaannuuffaaccttuurreerr’’ss ddeeccllaarraattiioonn -- eelleeccttrroommaaggnneettiicc iimmmmuunniittyy
PPoowweerr--PPRROO is suitable for use in the electromagnetic environment specified below. The customer or the user of PPoowweerr--
PPRROO should assure that it is used in such an environment.
IImmmmuunniittyy tteesstt
IIEECC 6600660011 tteesstt lleevveell
CCoommpplliiaannccee lleevveell
EElleeccttrroommaaggnneettiicc
eennvviirroonnmmeenntt--gguuiiddaannccee
Electrostatic discharge
(ESD)
IEC 61000-4-2
+6 kV contact
+8 kV air
+6 kV contact
+8 kV air
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30%. Applies to:
• PPoowweerr--PPRROO
• SSMMRRTT charger (6500-
201-010)
Electrostatic fast Transient/
burst
IEC 61000-4-4
+2 kV for power supply lines
+1 kV for input/output lines
+2 kV for power supply lines
+1 kV for input/output lines
Mains power quality should
be that of a typical
commercial or hospital
environment. Applies to:
• SSMMRRTT charger (6500-
201-010)
Surge
IEC 61000-4-5
+8 kV line(s) to line(s)
+2 kV line(s) to earth
+8 kV line(s) to line(s)
+2 kV line(s) to earth
Mains power quality should
be that of a typical
commercial or hospital
environment. Applies to:
• SSMMRRTT charger (6500-
201-010)
6516-209-001 Rev D.0 55 EN