pg 10
Power Up Modes
Dry Signal
The Dry Signal can be set in one of three different ways�
• Digital Mode uses the converted dry signal and allows the MIX knob to
dial out the dry signal when turned past the 3 o’clock position�
• Analog Mode keeps the dry signal in analog�
• Kill Dry Mode mutes the analog dry path signal, allowing the MIX
knob to strictly control the “wet” effect output level� This is often
preferable if using cloudburst within an amp’s parallel effects loop
or a mixer’s aux or effects send�
1 Press and hold the footswitch for at least 2 seconds while powering
up cloudburst� Once the LED flashes, release the footswitch�
2 Turn the TONE (DRY SIGNAL) knob to select one of the three Dry
Signal options� The LED will change color to indicate the current
status as you turn the knob�
• Digital Mode: GREEN (default, minimum)
• Analog Mode: RED (12 o’clock)
• Kill Dry Mode: BLUE (maximum)
3 Press the footswitch to store the Dry Signal setting and begin using
cloudburst�
To Next Page
Loading...
