pg 13
External Control
Expression Pedal Setup
Use a TRS expression pedal to remotely control the knobs of cloudburst�
By default, cloudburst is configured so that an Expression pedal controls
the MIX knob�
1 Configure the EXP/MIDI jack for Expression Mode� (See page 11 for
configuration instructions�)
2 Connect an expression pedal to the EXP/MIDI jack of cloudburst using
a TRS cable�
RIGHT IN LEFT OUT RIGHT OUT EXP
MIDI IN
USB
MIDI OUT
3 Press and hold the footswitch for at least 2 seconds, until the LED
blinks GREEN�
4 Rock your expression pedal to the HEEL position� The GREEN LED
will stop blinking and remain lit�
5 Set the knob(s) you would like to control to the desired settings for the
HEEL position of the expression pedal�
6 Rock the expression pedal to the TOE position� The LED will turn RED�
7 Set the knob(s) you would like to control to the desired settings for the
TOE position of the expression pedal�
8 Press and release the cloudburst footswitch to exit and store your
expression pedal setup�
NOTE: Your expression pedal assignment is saved per Favorite setting or
MIDI preset�
NOTE: If cloudburst is set to respond to MIDI EXPRESSION and the EXP/MIDI
jack is set to MIDI Mode, you can send MIDI CC# 100 with values 0 (heel) to
127 (toe) to perform the expression pedal setup�
To Next Page
Loading...
