pg 8
Power Up Modes
Bypass Mode for Mono I/O
With the rear I/O Mode Selector set to mono, the cloudburst pedal
is set for True Bypass as the default� Setting cloudburst to Buffered
Bypass Mode preserves the high frequency response of your
instrument’s signal through your pedal chain and long cable runs�
NOTE: With the rear I/O Mode Selector set to mono stereo or stereo, the
bypass mode is automatically set to Buffered Bypass�
1 Press and hold the footswitch for at least 2 seconds while powering
up cloudburst� Once the LED flashes, release the footswitch�
2 Toggle the ENSEMBLE (BYPASS MODE) switch to choose between
True or Buffered Bypass Modes� The LED will change color to
indicate the current status as you toggle the switch�
• True Bypass: set the switch to the off (left) position� The LED
lights GREEN (default)�
• Buffered Bypass: set the switch to the (right) position� The
LED lights RED�
3 Press the FOOTSWITCH to store the Bypass Mode and begin using
cloudburst�
NOTE: The Bypass Mode setting persists across power cycles�
To Next Page
Loading...
