Strymon cloudburst - Factory Reset; Performing a Factory Reset

pg 28
Factory Reset
Performing a Factory Reset restores the pedal to its factory default
Power Up functions, and replaces all stored presets with their factory
default settings�
1 Press and hold the footswitch for at least 2 seconds while powering
up cloudburst� Once the LED flashes, release the footswitch�
2 Press and hold the footswitch again and while still holding it down,
sweep the PREDELAY (FACTORY RESET) knob from minimum to
maximum and back two times� The LED will change colors at the
extremes of the knob range and flash RED to indicate when the
reset is taking place�
• TURN 1, from minimum t
o maximum: AMBER
• TURN 2, from maximum to minimum: RED
• TURN 3, from minimum to maximum: AMBER
• TURN 4, from maximum to minimum and release the footswitch
immediately: the LED flashes RED, cloudburst resets and
restarts