Strymon Zelzah - MIDI Functionality - MIDI Setup

Zelzah - Multidimentional Phaser
pg 23
INPUT
MONO
IN OUT L OUT R
STEREO
USB
INPUT
MONO
IN OUT L OUT R
STEREO
USB
MIDI Functionality – Configuring Zelzah to Use MIDI
Using MIDI unlocks a set of tools that can be used to load any of
Zelzah’s 300 preset locations using a suitable MIDI controller or
interface connected to Zelzah’s EXP/MIDI jack. This requires a
Strymon MIDI EXP cable or a MIDI controller/interface, such as
Strymon Conduit, with at least one quarter-inch output. When using
a Strymon MIDI EXP Cable, the MIDI OUT mode must be set to OFF.
(See page 27 for more info.)
Check strymon.net/support/zelzah for a list of compatible devices.
OR
MIDI Enabled Stompbox
MIDI Controller with
5-pin MIDI Outputs
MIDI Controller with
1/4" TRS Output
1/4" TRS
MIDI Interface
(such as Strymon Conduit)
MIDI EXP cable TRS cable
OR