EasyManua.ls Logo

Subaru 602 - Page 71

Subaru 602
162 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
71
June 2013
Electrical Systems Operation & Diagnosis Module (602)
Turning Your Vehicle Off
Press and hold the START (key icon) button again to turn the vehicle off. If the vehicle is left
running the remote start system will allow the vehicle to run for a total of 15 minutes and then
automatically turn off.
Entering the Vehicle While it is Running via Remote Start
1. Unlock the vehicle doors using the factory keyless remote. If the vehicles doors are unlocked
manually using the key, the vehicles security system will trigger and the remote start system
will turn off. Inserting the ignition key into the ignition cylinder and turning it to the ON or
Run position will disarm the security system.
2. Enter the vehicle. Do not press the brake pedal.
3. Insert the key into the ignition and turn to the ON position. If the ignition key is accidently
turned to the start position, the system’s “starter anti-grind” feature will prevent the starter
from re-cranking.
4. Press brake pedal. The RES disengages, the vehicles power window features are re-enabled
and the vehicle will operate normally.
To engage the service mode, turn the ignition key to the ON or Run position, depress and hold the
brake pedal then, press and release the START (key icon) button on the remote control transmitter
three (3) times. The system will pause for one second and then flash the parking lights three (3)
times indicating the system is in service mode. When attempting to activate the remote start system
while in service mode, the parking lights will flash three (3) times and will not start.
To disengage the service mode, turn the ignition key to the On or RUN position, depress and
hold the brake pedal, then press and release the START (key icon) button on the remote control
transmitter three (3) times. The system will pause for one second and flash the parking lights one
(1) time indicating that the system has exited service mode.
* *Key in ignition or hood open, inspection mode connector connected
Important Note: When taking your vehicle in for service, it is recommended that
you inform the service personnel that your vehicle is equipped
with a remote start system.

Table of Contents

Related product manuals