Notes:
1. Brake type may dier depending on specication. Check the nameplate.
2. Brake torque will change according to operating environment, operating conditions, the condition of the
friction surface, etc. In particular, brake torque may not be at the prescribed level for initial operation, and
after a long period of inactivity. In such a case turn the brake on and o under as light load as possible to
contact the brake’s friction surfaces.
3. Brake activation delay time will change according to the brake’s wiring circuit. Select the optimum circuit
for the application.
•
Do not put ngers or foreign objects into the opening of the products; otherwise, electric shock, injury,
re, or damage to the equipment may result.
•
The products become very hot during operation. Touching the unit with bare hands may result in
serious burns.
•
Do not touch the terminals when measuring insulation resistance; otherwise, electric shock may result.
•
Do not operate the unit without a safety cover (removed during inspection) in place to shield rotating
parts; otherwise loose clothing may became caught in these rotating parts and cause serious injury or
death.
•
Promptly identify and correct, according to instructions in this maintenance manual, any abnormalities
observed during operation. Do not operate until the cause for the abnormality is understood, and the
abnormality is corrected.
•
Change lubricant according to the maintenance manual instructions. Be sure to use factory approved
lubricant.
•
Only install, move, or transport oil-lubricated models with lubricating oil removed. Moving with
lubricating oil in the machine may cause oil to escape from the air vent, etc.
•
Do not change lubricant during operation or immediately after stopping operation; otherwise, burns
may result.
•
Supply/discharge grease to/from the motor bearing according to the maintenance manual instructions.
•
Do not handle the unit when cables are live. Be sure to turn o the power when operating on the unit;
otherwise, electric shock may result.
•
Do not approach or touch any rotating parts (slow speed shaft, etc.) during run-time maintenance or
inspection of the unit; loose clothing may become caught in these rotating parts and cause serious
injury or death.
•
Customers must not disassemble or modify for explosion proof motors; otherwise, explosion, ignition,
electric shock, or damage to the equipment may result.
•
The lead-in condition of explosion proof motors, shall conform to the facilities electrical codes,
extension regulations, and explosion- proong guide, as well as the maintenance manual; Additionally,
do not open the terminal box cover while operating. otherwise, explosion, ignition, electric shock, or
damage to the equipment may result.
•
Do not operate the machine while the brake is released by the manual brake release bolt; otherwise,
falling, going out of control, or damage to the equipment may result.
8. Daily Inspection and Maintenance
www.SumitomoDrive.com
Cyclo® 6000 Operating and Maintenance Manual
Cyclo® 6000 Cyclo® 6000
Cyclo® 6000 Operating and Maintenance Manual
34 35
7. OPERATION 8. DAILY INSPECTION AND MAINTENANCE
To Next Page
Loading...