Sumitomo Drive Technologies Cyclo 6000 - 3. TRANSPORT; 4. INSTALLATION

4. INSTALLATION3. TRANSPORT
Do not stand directly under a unit suspended by a crane or other lifting mechanism; otherwise, injury, or
death may result.
•
Care should be taken to not drop the unit.
•
When a hanging bolt or hole is provided, be sure to use it. After mounting a unit to a machine, do
not hoist the entire machine using the hanging bolt or hole; otherwise it may result on personal
injury or damage to the equipment and/or lifting device.
•
Before hoisting, refer to the rating plate, crate, outline drawing, catalog, etc., for the weight of the
unit. Never hoist a unit that exceeds the rating of the crane or other mechanism being used to lift it;
otherwise it may result on personal injury or damage to the equipment and/ or lifting device.
•
When the products are lifted, use suitable lifting parts, and conrm which eye-bolts and nuts are
not loose.
•
Oil lubricated units should be handled dry (free of lubricant) before mounting, moving, and
transporting. Handling the unit with lubricating oil inside the machine may cause oil to escape from
the air vent.
•
Do not use a standard unit in an explosive environment (which is likely to be lled with explosive
gas or steam). Under such conditions, an explosion proof motor should be used; otherwise it may
result on electric shock, personal injury, explosion, re, or damage to the equipment.
•
In the case of motors, use an explosion proof motor that meets the specic requirements for
explosive environments (a location where gas or volatile vapor is present); otherwise it may result
on explosion, ignition, electric shock, injury, re, or equipment damage.
•
When an explosion proof motor is driven by an inverter, and the inverter itself is not explosion
proof, install the inverter in a place free from explosive gas; otherwise it may result on electric shock,
personal injury, explosion, re, or damage to the equipment.
•
Do not use the products for purposes or conditions other than the ones specied on the nameplate
or purchase order; otherwise it may result on electric shock, personal injury, or damage to the
equipment.
•
Do not place ammable objects around the gearmotor; otherwise it may result on re.
•
Do not place any object around the gearmotor or reducer that will hinder ventilation. Insucient
ventilation can cause excessive heat build-up that may result in burns or re.
•
Do not step on or hang from the gearmotor or reducer; otherwise it may result on personal injury.
•
Do not touch the shaft end of the gearmotor or reducer, inside keyways, or the edge of the motor
cooling fan with bare hands; otherwise it may result in personal injury.
•
When the unit is used in food processing applications, machines for cleanroom or applications in
which the lubricant might contaminate manufactured or processed goods, install an oil pan or
other device to protect from oil leakage due to breakdown or failure; otherwise oil leakage may
contaminate manufactured or processed goods.
•
Always drain oil lubricated models before mounting, moving, and transporting. Moving with
lubricating oil in the machine may cause oil to escape from the air vent.
www.SumitomoDrive.com
Cyclo® 6000 Operating and Maintenance Manual
Cyclo® 6000 Cyclo® 6000
Cyclo® 6000 Operating and Maintenance Manual
14 15
3. Transport 4. Installation