Sumitomo Z2C - 1. Introduction; Product Overview

1-1
1. Introduction｜Product overview
1．Introduction
❚
Product overview
The Z2C automatically pre-inspects
and aligns a pair of optical single
fibers with equipped microscopes,
and then fuses them together with
heat from an electric arc to form a
low-loss splice. A protection sleeve is
applied over the bare glass and cured
in the built-in heat shrink oven.
Read this manual carefully in its entirety to fully
understand machine capabilities. Save this manual in a
location in which you can easily get to see.
●
Optical fiber requirement
The Z2C can splice the following optical fiber types.
*1 Fiber diameter except 125μm are only applied in room temperature and 0m altitude.
*2 The applicable fiber protection sleeves vary depending on the cleave length.
*3 Over 250μm coating diameter with the length less than 8mm require fiber holder operation.
Material Silica glass
Profile types
SMF (ITU-T G.652), MMF (ITU-T G.651),
DSF (ITU-T G.653), NZDSF (ITU-T G.655, G.656),
BIF (ITU-T G.657)
Fiber diameter
80 - 150μm
*1
Fiber coating diameter 100 - 1,000μm
Fiber count Single fiber
Cleave length
*2
5 - 16mm
*3