Sumitomo Z2C - Customizing Heater Program

5-3
5. Heater program｜Customizing heater program
5. Heater program
3: Select the heater program you
would like to edit.
5: Delete the current value using
icon first, and then edit the
value and tap Done ( ).
*Std: is the default value.
1: On the “Heater Program
screen” (▸P.2-10), Select the
sleeve type where you would
like to change the settings.
2: Tap the Pencil icon ( ) at
the right upper corner of the
screen.
4: Select the parameter you
would like to edit.
An editable parameter has a >
mark ( ) at the rightmost part
of the row.
❚
Customizing heater program
Heater program can be customized as per your requirement by editing parameters
set in the program.
Small pencil icon ( ) appearing at the
upper right-hand corner of item names
In the above example, Heating Duration B is
changed to 22 sec from the default 0 sec. Af-
ter the default value of an item has been
changed, a small pencil icon ( ) appears at
the upper right-hand corner of the item
name, enabling a user to understand the
Default value has been
changed.