4-4
4.Splice program｜Copying splice program(in Administrator mode)
4. Splice program
❚
Copying splice program (in Administrator mode)
1: On the “Splice Program screen”
(▸P.2-9), select the fiber category
where you would like to change
the settings.
In Administrator mode, you can create your own new splice program by copying
an existing splice program to a blank area of splice programs. After the copy, you
can edit the name of the copied program and change the parameter settings.
First, log in to Administrator mode to do this action.
(▸P.8-1 Logging in to and logging out of Administrator mode)
3: Tap ( ). A pull-down menu
appears. Select Copy ( )
from the pull-down menu that
appears.
4: Select the program you want
to copy and tap Done
( ). Next, select where
you want to paste the copied
program and tap Done
().
5: You can edit the name of the
copied program and change
the parameter settings.
2: Tap the Pencil icon ( ) at
the right upper corner of the
screen.
Splice Program edit screen
An editable item has a > mark ( )
at the rightmost part of the row.
▸P.4-3 Customizing splice program
To Next Page
Loading...
