Sumitomo Z2C - Packing and Storage Instructions

3-8
3. Maintenance｜Packing and storage instructions
3. Maintenance
The Z2C fusion splicer is a precision instrument. Its rugged shipping case is custom
designed to protect it from impact, dust, dirt, and moisture. Always store and transport
the machine in its case.
• Store the Z2C and its accessories in a designated place in the case referring to the
photo below.
• Store the Z2C in the direction shown in the photo below.
• The Z2C with a cooling tray cannot be stored in the case. Remove the cooling tray
from the splicer and store it in the pocket.
Observe the following instructions.
• Clean the Z2C and all accessories before storing them.
• Be sure to remove the battery pack from the Z2C and store it in the dedicated space
located under the splicer.
• Reposition the monitor before storing.
• Discard the liquid solvent properly, or lock the dispenser completely and put it in a
plastic bag before packing the dispenser in the case.
• Before storing the fiber cleaver, dispose of the fiber fragments collected in the off-cut
collector in a proper way.
• Close the carrying case completely and latch it before transportation.
• Pay attention to storage temperature and dew condensation when storing the splicer.
The battery is self-discharged during storage. Perform temperature control and
charge and discharge the battery once every 6 months.
Storage temperature -20°C ~ +50°C (if stored for less than 1 month)
-20°C ~ +40°C (if stored for less than 3 months)
-20°C ~ +20°C (if stored for less than 1 year)
Fiber cleaver
(Optional*)
Jacket remover
(Optional*)
Carrying case
Cooling tray
Spare electrodes
Z2C
Battery pack
(stored in the dedicated
space under the splicer)
Quick reference guide
AC power cord
AC adapter
Fiber holders
(Optional*)
*Sold separately
Strap for
carrying case
❚
Packing and storage instructions