Sumitomo Z2C - Screens and Icons

1-10
1. Introduction｜Screens and icons
1．Introduction
●
Home screen
❚
Screens and icons
After the splicer is turned on, Home screen is displayed.
Settings panel icon: Display the Settings panel.
Power source type: Shows AC power or battery power.
For battery use, the battery icon shows the battery level. When the battery icon is tapped,
estimated splice cycles per remaining capacity is displayed.
Change image view: Shows the currently selected image view type.
When the icon is tapped, the image view type is changed to (dual, tandem) ⇒
(dual, side by side)
⇒ (single) ⇒ (single) .
Show/hide icons at the top of the screen.
Start the splicing process.
Splice program Heater program SD Power Time
Heater panel
Control panel
Heater progress
bar
Heater panel
Start the heating process.
Control panel
View splice data after splicing.
Adjust the zoom of a fiber image viewed on the screen. (Avail-
able when or is selected)
Adjust display brightness.
Capture a fiber image on the screen.