8-3
8. Administrator mode｜Lock functions
8. Administrator mode
The security settin
requires an operator to enter a password upon startup of
the Z2C on a specified date.
1: Open the Administrator
settings panel. Tap “Password
Settings”.
2: Tap “Security Settings”. On the
next screen, tap OFF( ) in
“Security”.
4: Enter a min.4 to max.16 digit
startup password, and then
tap “Done” ( ).
Reenter the password for con-
firmation, and then tap “Done”
().
5: Enter a date when the splicer
will request a password entry.
Change the dates using
icons, and then tap “Done”
( ). Past dates cannot be
set.
❚
Lock functions
●
Startup password protection
6: Security setting is enabled.
3: You’ll be directed to the startup
password setup screen.
To Next Page
Loading...
