Sumitomo Z2C - Inserting the Fiber into the Splicer

2-26
2. Basic splicing operation｜Drop cable splicing
2. Basic splicing operation
1. Open the hood.
2. Load prepared drop cable in the splicer as shown in the picture below
.
4. Close the hood.
5. Start the splicing process.
(Note: Perform an arc test before splicing.)
3. Make sure that the fiber sits in the V-groove correctly.
For use of 40mm protection sleeve
For use of 60mm protection sleeve
●
Inserting the fiber into the splicer
Groove
For details on arc test and splicing
procedures, please refer to the page
below.
▸P.2-15 Arc test
▸P.2-17 Starting the automatic splice