2-4
2. Basic splicing operation｜Preparing power supply
2. Basic splicing operation
Install the battery pack (BU-16) into the slot of the Z2C as described below.
Turn off the splicer and disconnect the AC adapter from the splicer before installing and
removing the battery pack.
▸P.2-5 “Battery charging”
▸P.2-6 “Battery level check”
Opening and closing the cover of the battery pack slot
①Insert the tab of the
cover into the slot.
Close the cover.
②Lock the cover securely.
Lock
Tabs
Battery pack installation
Insert the battery pack straight all
the way in the slot.
Battery pack removal
Open the cover of the slot. Hook
your finger to the projection of the
battery pack, and then slide it out in
the direction of the arrow.
2
●
Battery operation
①Slide the lock in the
direction of the arrow to
unlock the cover.
②Open the cover.
Locked
Unlocked
1
1
2
Projection
Open Close
To ensure drip-proof and dust-proof performances, close the battery cover securely.
To Next Page
Loading...
