Sumitomo Z2C - Hand Strap

7-6
7. Other convenient functions｜Hand strap
7. Other convenient functions
❚
Hand strap
The hand strap is supplied with the Z2C. Secure it to the splicer referring to the
following procedures.
Buckle Strap
Seam allowance
faces down
Rib faces up
4: Flip up the strap and thread it into
the buckle as shown below.
5: Adjust the buckle position and pull
the strap to tighten.
Repeat the same steps for the other
side.
Caution
If the buckle or strap is fitted wrong side out or the strap is not
threaded through the buckle correctly, the Z2C may fall.
1: Make sure the buckle and strap are
right side up as shown below.
2: Thread the strap through the buckle as
shown below.
3: Thread the strap into the strap hole of the
splicer.