The Gas Analyser Maintenance Menu allows operator maintenance
functions to be initiated, gas analyser system settings to be made,
gas analyser system information to be consulted and updates to the
gas analyser software to be loaded. Refer to 5.2: „The Gas Analyser
System Menu‟ for further information.
•
To return to the Gas Analyser Menu, press the “Home” icon button
on the toolbar.
•
To place the Gas Analyser in Standby Mode, press the “Standby” icon
button on the toolbar.
Once the Gas Analyser is switched on, it should remain on for the
whole working day, however, it is recommended that the unit should
be put into Standby Mode when tests are not being performed. This
will reduce wear and tear to the pump and increase the effective
life of the filters.
The unit will return to the normal operating mode when:
-
The “Standby” button is pressed once more, or
-
One of the Gas Analyser Main Menu option buttons (“Free
Measurement” or “System Setup”) is pressed.
On leaving the Standby Mode, a Zero-calibration and HC Residue Check
will automatically be performed before the unit returns to normal
operation.
18
To Next Page
Loading...