6.1
Connections
For your own and other people’s safety the DGA 5000 must only be
used in a well-ventilated clean air environment.
6.1.1
Power Connections
Before making any power connections ensure that the mains power
switch is set to “off” and that the mains voltage selector switch is
set to correspond with the local mains supply voltage.
Power is supplied to the Gas analyser from the Emissions Diagnostic
Platform electrical distribution block via an electrical input socket located
on the rear panel of the Gas Module (see 4.2: „Gas Module Layout‟).
6.1.2
Data Connections
Communication between the PC. Gas Module takes place via the USB
(Universal Serial Bus) connectors located on the Gas Module rear panel
(see 4.2: „Gas Module Layout‟).
•
Connect the PC USB port to the Gas module via the USB P.C.
interface connector on the Gas Module side panel.
Note:
If the DGA 5000 is used in conjunction with an EOBD Device, the unit will
derive rpm and oil temperature data direct from the test vehicle engine
management system via the EOBD unit. In this case the use of the ROTI
Module is unnecessary.
•
Connect the Printer (wirelessly), Mouse and Keyboard to the P.C.
Printer, Mouse and Keyboard ports.
26
To Next Page
Loading...