•
To open the Print Preview Window, press the “Print Preview” toolbar
button on the The Free Measurement Screen toolbar.
The Print Preview Window will be displayed. The window shows the
measurements stored in the data buffers (1 & 2) together with the
limit values applied. By using the text buttons in the Print Preview
Window it is possible to:
-
Delete either or both sets of test measurements.
-
Proceed to the “Print” Window.
•
To delete data stored in buffer 1 (Limit Set 1), press “Delete Set 1”.
The gas measurements stored in buffer 1 will be deleted.
•
To delete data stored in buffer 2 (Limit Set 2), press “Delete Set 2.
The gas measurements stored in buffer 2 will be deleted.
Note:
Pressing the delete buttons in the Print Preview Window will only cause
the stored test data to be deleted. The limit set values will continue to be
shown and applied until either a new vehicle setup (having different limit
values) is applied or the limit sets are disabled.
•
To access the Print Screen, press the “Print” button.
•
To return to the The Free Measurement Screen, press the “Back”
button.
8.8
Printing Test Results
Refer to 5.6: „Print‟ for information on printing test results
51
To Next Page
Loading...