Sun Microsystems DGA 5000 - 9.7 Error, Warning and System Status Messages

9.6.6 General
 The exterior of the cabinet may be cleaned using a damp soft lint-
free cloth. Use a mild detergent to remove grease.
Do not use solvents (acetone, benzine etc.). These can damage
plastic components and affect sampling accuracy if they
contaminate the sampling system.
 Clean up any liquid spills immediately to protect the exterior of the
unit and to prevent any spillage from entering the ventilation
vents.
 Test leads and the main power cable may be cleaned by using a
water-free hand-cleanser and wiping dry with a cloth.
9.7 Error, Warning and System Status
Messages
The DGA 5000 system gives error, warning and system status
messages in two ways:
- By means of automatic pop-up windows.
- By means of the “Error/Warning” button on the toolbar.
9.7.1 Automatic Pop-up Windows
Automatic pop-up windows will be displayed to indicate the following
system statuses:
- Warm-up
- Zero-calibration.
- HC residue check .
66
ERROR, WARNING AND SYSTEM STATUS MESSAGES