6.1.3
Gas Module Pneumatic Connections
•
Connect the Exhaust Sample Probe and Hose to the Gas Sample
Inlet on the Gas Module rear panel.
Note:
Do not insert the Sample Probe into the vehicle exhaust tailpipe at this
stage.
6.2
Start-Up
6.2.1
Power Up
•
Set the Main, PC and Gas Module power switches to “On”.
The PC will load the Windows Operating System. After a short
interval the Windows desk-top will be displayed.
Note:
For normal operating purposes it is recommended that the PC and Gas
Module power switches be left permanently in the “On” position and that
the unit be turned on and off with the Diagnostic Platform main power
switch.
•
Select the SUN
®
Diagnostic Platform program using either the
Windows start menu or the shortcut on the desk-top.
The operating system will load the software and the Gas
Analyser Menu will be displayed (see the Diagnostic Platform
Operator‟s Manual 5.1).
•
Select the Gas Analyser option from the Main Menu.
Selecting the Gas Analyser mode will display the Gas Analyser
Menu (see 5.1).
Note:
The body of this manual concerns the operation of the DGA 5000 in Gas
Analyser mode only. Information concerning the use of the unit in
conjunction with the Diesel Smoke Meter, EOBD Device menu
options will be provided as separate documentation.
27
To Next Page
Loading...