Sun Microsystems DGA 5000 - 5.4 Gas Analyser System Settings

• To Check and/or Install the O2 Cell, select the O2 Sensor Check
Option.
Details of the procedures for these checks are to be found in
10: „Maintenance‟.
5.4 Gas Analyser System Settings
.
Figure 5-6 The Gas Analyser System Settings Screen
To access the Gas Analyser System Settings Screen, select the “System
Settings” option from The Gas Analyser Maintenance Menu (see 5.2).
The Gas Analyser System Settings Screen comprises drop-down menus
for the selection of:
- Lambda/AFR.
- Summertime On/Off.
- LPG composition.
• Use the “Summertime On/Off” drop-down menu to switch between
Summertime/Wintertime.
The Summertime/Wintertime information is required by the gas
module for the calculation of daily leak check and gas calibration
intervals.
• Use the Lambda/AFR drop down menu to select either Lambda or Air
Fuel Ratio (AFR).
Depending on the selection, the unit will calculate and display either
Lambda or Air Fuel Ratio.
21
C H A P T E R 5