Routing Administration 14-3
14
Routing Procedures
Static Router
▼ To Configure the Netra system as a Static Router
Note – Before using static routing over PPP links, do the following:
• Configure a PPP connection to the remote host using the HSI, ISDN or
Modem Administration modules.
• Add a static route to the remote host's Host Address.
1. Select Network Connection Administration: Routing ➤ Configure static
router.
The Static Router Administration page is displayed.
2. Enter the information in form using Table 14-1.
▼ To Modify a Static Router
1. Select Network Connection Administration: Routing ➤ Modify static
router.
2. Make the changes in the form using Table 14-1.
Table 14-1 Information for Static Router
Default Router Host
Address
Host address of the default router for the network.
Destination Network/
Host Address
Network/Host address to which information is routed.
Router Host Address Host address of the router used for accessing the
destination address.
Hop Count A value of 0 or greater. 0 means the Netra server is the
router; a value greater than 0 means that another system is
the router.
To Next Page
Loading...
