4-2 Netra Internet Server 3.1 User’s Manual—September 1996
4
Using a Monitor for Initial Configuration
▼ To Prepare for Configuration
1. Physically connect the Netra server to the LAN, and attach the monitor
and keyboard. (Refer to your Netra hardware installation manual for
instructions.)
2. Obtain the following configuration information for your site:
• System Defaults (See Chapter 19, “Netra System Administration.”)
• Host name for your Netra server (See Chapter 19, “Netra System
Administration.”)
• System administrator alias members (See Chapter 19, “Netra System
Administration.”)
• Root password (See Chapter 18, “Root Password Administration.”)
• Administration Web Server password (See Chapter 15, “Administration Web
Server.”)
• LAN interface information: host address and netmask for a TCP/IP
network, or network number and frame type for an SPX/IPX network.
(See Chapter 12, “Local Area Network Administration.”)
▼ To Log In to the Netra Server
1. Power on the Netra server.
2. At the NewNetra console login prompt, enter setup.
Note that an unconfigured Netra server uses the name NewNetra.
3. At the Password prompt, enter setup again.
The Netscape browser is automatically started on your system, and a
Netscape Password window is displayed.
4. Enter setup for the User ID; then enter setup for the Password.
The Netra Welcome page is displayed.
To Next Page
Loading...
