Sun Microsystems Netra - Save and Restore Procedures

19-12 Netra Internet Server 3.1 User’s Manual—September 1996
19
Save and Restore Procedures
▼ To Eject a Diskette
♦ Select System Administration: Save and Restore Configuration ➤
Eject diskette.
The Eject Diskette page is displayed, telling you that the diskette has been
ejected.
▼ To Save the System Configuration
1. If you are saving to diskette, insert the diskette into the drive; otherwise
proceed to Step 2.
Make sure the diskette is not write protected.
2. Select System Administration: Save and Restore Configuration.
The Save And Restore Configuration Administration page is displayed.
3. Select either Save configuration to diskette or Save configuration to file
system; then confirm the operation.
▼ To Restore the System Configuration
1. If you are restoring the configuration from a diskette, insert a diskette into
the drive; otherwise proceed to Step 2.
2. Select System Administration: Save and Restore Configuration.
The Save And Restore Configuration Administration page is displayed.
3. Select either Restore configuration from diskette or Restore configuration
from file system.
4. Make the entries in the form using Table 19-8.
Table 19-8 Information for Save/Restore Configuration
Restore entire configuration Restores all configurations from the diskette/disk.
Restore selected configurations Restores only the selected configurations from the
diskette/disk. If you select this option, you must
also select at least one configuration; if you select
any configurations, you must also select this option.