19-10 Netra Internet Server 3.1 User’s Manual—September 1996
19
Restart and Shutdown
Use the Restart and Shutdown module to restart or shutdown the Netra server.
You may need to restart the Netra server when you add new devices.
All users who are logged in to the Netra server receive a message before these
operations are performed.
▼ To Restart or Shut Down the System
1. Select System Administration: Restart and Shutdown.
The Restart and Shutdown Administration page is displayed.
2. Enter the information in the form using Table 19-7.
Table 19-7 Information for System Restart/Shutdown
Shut Down Shuts down and powers off the Netra server.
Restart Restarts the Netra server.
Check for new devices
during restart?
If this option is selected, the operating system regenerates
the list of devices attached to the Netra server. Use this
option if you add a tape drive, CD-ROM drive, external
hard disk, or network interface hardware to your server.
Delay (in minutes) The time, in minutes, after which the Netra server will
shut down or restart.
To Next Page
Loading...
