ATM Administration 9-3
9
Configuring ATM Interfaces
To configure ATM interfaces on the Netra server, you must perform the
following general tasks:
1. Set the type of framing interface.
ATM switches use either the SDH or the SONET framing interface.
(The framing interface used by your ATM switch should be in the switch
product information.) Set the framing interface type using the Change
Framing Interface option, as described on page 9-4.
2. Set the User Network Interface (UNI) version for each ATM port.
Each ATM port must be configured with a User Network Interface version.
This version will apply to all Classical IP and LAN Emulation interfaces
configured on that port. Each port can be configured with a different
version. Set the UNI version using the Change User Network Interface
Version option, as described on page 9-4.
3. Configure a Classical IP and/or a LAN Emulation interface for each ATM
port.
Use the Configure a Classical IP Interface and Configure a LAN
Emulation Interface options described on page 9-5 and page 9-6.
To Next Page
Loading...
