Sun Microsystems Netra - ATM Procedures; Framing Interface; User Network Interface

9-4 Netra Internet Server 3.1 User’s Manual—September 1996
9
ATM Procedures
Framing Interface
▼ To Change the Framing Interface
1. Select Network Connection Administration: ATM.
The ATM Administration page is displayed with the current switch and port
configuration information.
2. Select Change Framing Interface.
3. Select the type of framing interface (see Table 9-1).
4. Restart the Netra server using System Administration: Restart and
Shutdown.
User Network Interface
▼ To Change the User Network Interface Version
1. Select Network Connection Administration: ATM.
The ATM Administration page is displayed with configuration information
for each port.
2. Select Change User Network Interface for the required ATM port.
3. Select the version number (see Table 9-2).
4. Restart the Netra server using System Administration: Restart and
Shutdown.
Table 9-1 Information for ATM Framing Interface
Framing Interface The supported ATM switch framing interface. The Netra
default framing interface type is SONET.
Choices: SONET, SDH
Table 9-2 Information for ATM User Network Interface
User Network Interface
(UNI)
The version of the UNI specification used for signalling.
The default version is 3.0.
Choices: 3.0, 3.1