12-1
Local Area Network Administration
12
This chapter describes how to configure the local area network (LAN)
interfaces on your Netra server using the Local Area Network module.
Note – The Netra software will only display information about network
interface hardware that is currently attached to the Netra server. (Refer to your
Netra hardware installation manual for instructions on adding network
interface hardware. See the “Software Management” module in Chapter 19 for
any software installation instructions.)
What is a Network Interface
A network interface consists of three elements:
• Network Port
The network port provides the physical link between machines that
comprise a network. Ports can be built into the Netra server, or they can be
provided by SBus cards in the server. The Netra server supports the
following types of network hardware:
• Lance Ethernet
• Fast Ethernet
• Fast Ethernet 100 Base-T
• Quad Ethernet
• Token Ring
To Next Page
Loading...
