4-1
Performing the Initial
Configuration
4
Before you can use the Netra server for any administration tasks, you must
configure it with information that is specific to your site. This chapter describes
the options for performing the initial configuration.
Options for Initial Configuration
You have two choices when performing the initial configuration:
• If you have a monitor for the Netra server, you can perform the initial
configuration using the monitor. (See page 4-2.)
• If you do not have a monitor, you must perform the initial configuration
using a PC on the LAN. (See page 4-6.)
Note – Another, less-used configuration option is described in Appendix C,
“Initial Configuration Using TTY.” If you do not have a monitor for the Netra
server, you can also connect a TTY terminal to it and complete the initial
configuration using a browser on a client system.
To Next Page
Loading...
