Netra System Administration 19-11
19
Save and Restore Configuration
If you make any changes to your system configuration, you should always
save the new configuration to a diskette or to a system hard disk. Use the Save
and Restore Configuration module to save your Netra system configuration to
a diskette or system disk, or to restore a previously-stored configuration from
such media.
Save and Restore Options
The following options are available:
• Eject diskette*: This option ejects a diskette from the drive. If you save or
restore your system configuration to or from a diskette, the diskette is
ejected at the end of the operation.
• Save configuration to diskette*: This option saves your current system
configuration to the diskette in the drive. If you use an unformatted
diskette, it is formatted as part of the save process.
• Save configuration to file system: This option saves your current system
configuration to a system hard disk.
• Restore configuration from diskette*: Either all or selected configurations
on the diskette are restored to the Netra system. This option is displayed
only if there is a valid Netra 3.1 system configuration on the diskette.
• Restore configuration from file system: Either all or selected configurations
on the hard disk are restored to the Netra system. This option is displayed
only if there is a valid Netra 3.1 system configuration on the hard disk.
Note – *To use these options, first make sure you have inserted a diskette in
the drive. If there is no diskette in the drive, the module will not display these
options, but will prompt you to insert a diskette and check the drive again.
To Next Page
Loading...
