B-2 Netra Internet Server 3.1 User’s Manual—September 1996
B
1. Insert the Netra Internet Server: Recovery CD-ROM into the Netra CD-ROM
drawer.
2. Ensure that your installation medium is CD-ROM.
Refer to the Software Management section in Chapter 19, “Netra System
Administration,” for more information.
3. Continue to use the Software Management module to install the software,
as follows.
• If you are installing the Solstice Backup 4.2.2 software:
a. Install the packages listed in Table B-1.
b. Install the patch shown in Table B-2.
• If you are installing the Solstice DiskSuite 4.0 software:
a. Install the packages listed in Table B-3.
b. Install the patch shown in Table B-4.
*This is an update to the -03 patch, which is also on the Recovery CD-ROM.
Table B-1 Solstice Backup Required Installation Packages
SUNWsbuab Solstice Backup 4.2 Answerbook
SUNWsbuc Solstice Backup (Backup/Recover) Client
SUNWsbum Solstice Backup (Backup/Recover) Man
SUNWsbus1 Solstice Backup (Backup/Recover) Server
SUNWsbus2 Solstice Backup (Backup/Recover) Device Drivers
Table B-2 Solstice Backup Required Installation Patch
103480-01 SPARC: Solstice Backup 4.2.2 Jumbo patch
Table B-3 Solstice DiskSuite Required Installation Packages
SUNWabmd DiskSuite 4.0 Answerbook
SUNWmd Solstice DiskSuite
SUNWmdg Solstice DiskSuite Tool
Table B-4 Solstice Backup Required Installation Patch
102580-08* Solstice DiskSuite 4.0: Jumbo patch