ISDN Administration 11-5
11
▼ To Modify or Delete Remote Host Connections
1. Select Network Connection Administration: ISDN Administration.
The ISDN Administration page is displayed.
2. Select one of the following:
• To modify an existing interface, select Modify, and make the changes in the
form using Table 11-1.
• To delete the existing interface, select Delete; then confirm the operation.
Local Port Assignments
Note – Profile B and SPID numbers should only be used in the U.S.A.
▼ To Configure a Port
1. Select Network Connection Administration: ISDN Administration ➤
Configure Port x.
2. Enter the information in the form using Table 11-2.
Table 11-2 Information for Configuring a Port (ISDN)
Switch Type Specifies the type of switch to which your ISDN line is
connected. This information is available from your phone
company or ISP. Choices: au1 (Australia); vn3, vn6 (France);
1tr6 (Germany); ntt (Japan); bt2 (United Kingdom); dms, 5ess,
ni2 (North America); etsi (Europe); swd-etsi (Sweden);
hkt (Hong Kong)
Profile A
Force 56Kb Forces the ISDN line to a 56Kb transfer rate, regardless of
how the incoming call identifies itself. This is mainly used to
solve incompatibility problems between switches.
Choices: On, Off
Calling Line Identify Enables or disables exchange service (if available) where the
exchange verifies that the local calling number is the phone
number of the calling system.
To Next Page
Loading...
