Client System Requirements 2-3
2
If the NetWare server has the following SPX/IPX configuration:
• Frame type: Ethernet_802.3
• IPX network number: 12345678
then the network interface for the Netra server on that LAN should also have
the same SPX/IPX configuration: a frame type of Ethernet_802.3 and an IPX
network number of 12345678.
If you have two frame types on the NetWare server, you can choose either one
or both frame types (you must use at least one of them). If you choose both
frame types, the same rule applies: the IPX network numbers that are used on
the NetWare server must also be used on the Netra server.
Use the IPX Gateway diskette that was shipped with your Netra server to
install the IPX Gateway software on each client system. The program used to
install the software is called setup.exe. It should be run on each client PC or
installed on a file server.
▼ To Install IPX Gateway on the Client PC
1. Insert the IPX Gateway diskette into drive A on the client PC.
2. Start File Manager on the client PC and access drive A.
3. Double click on the setup.exe file name (or icon) to start the installation
program.
An “Initializing Setup” screen is displayed, followed by a client setup
screen.
4. Select Express Setup.
A setup window is displayed, showing the status of the installation.
Once the IPX Gateway is installed, a screen showing that the installation is
complete is displayed. Then icons labeled Internet Junction Client
and Release Notes are displayed on the client system.
To Next Page
Loading...
