4-4 Netra Internet Server 3.1 User’s Manual—September 1996
4
8. Select the highlighted Host Name option.
The Host Name Administration page is displayed.
9. Enter the name for the Netra server.
A message saying the Netra server needs to be restarted is displayed. You
can restart the Netra server once you finish configuring it.
Note – If you choose to restart the Netra server immediately, you must repeat
the initial login sequence (notice that the new host name is used) to bring you
to the Initial Configuration page. At this point, the Host Name option will not
be shown as one of the remaining configuration tasks. Proceed to the next
administration module.
10. Use the Forward Arrow icon to go to the next configuration task.
11. Complete the System Administrator Alias, Root Password,
Administration Web Server, and Local Area Network configuration tasks.
Note – If you change the Administration Web Server password, you must
reauthenticate the browser connection.
12. Use the Forward Arrow icon to go to the Main Administration page.
The Main Administration page is displayed.
▼ To Complete the Configuration
1. Use the displayed modules to perform any further system configuration
tasks (such as setting up mail aliases, configuring a name service, or
setting routing options).
Refer to the relevant chapters in this manual for more information on each
administration module.
2. Once the Netra server is completely configured, save the configuration
information as follows:
a. Insert a blank diskette into the Netra disk drive.
If you do not have a diskette drive on your Netra server, proceed to
Step b.
b. Select System Administration: Save and Restore Configuration.
To Next Page
Loading...
