Cartridge Management Tasks
96116 • Revision: KA Chapter 3 SL500 Automated Library Operations 89
â–¼ Move a Specified Cartridge by VOLID
Use this procedure to move a cartridge with a specified VOLID to a specified location
within the library.
Note – This procedure updates the cartridge’s location in the library controller
database, but not in the host database. Therefore after performing this procedure, you
must perform an audit from the host software to update the host database. Failure to
do so will cause future mount requests from the host software to fail.
Caution – Use caution when performing this procedure in partitioned libraries. You
could inadvertently move a cartridge from one partition to another, allowing the new
partition to overwrite data on the cartridge.
1. Select Tools > Diagnostics, and click the Library folder.
2. Click the RcvrMove tab.
The Recovery Move screen appears.
3. In the Source Location Mode field, click VOLID.
To Next Page
Loading...
Need help?
General
