96116 • Revision: KA xxiii
Figures
FIGURE 1-1 Front View of Library Components 2
FIGURE 1-2 Back View of Library Components 3
FIGURE 1-3 Buttons and Indicators 12
FIGURE 1-4 Robotics Components 20
FIGURE 1-5 Hand Assembly 21
FIGURE 1-6 Library Interfaces Locations 24
FIGURE 3-1 Base Module Magazine Comparison 86
FIGURE 6-1 Library Partition Example 147
FIGURE 9-1 Insert Mixed Media Cartridges into Arrays 323
FIGURE 9-2 Insert Cartridge into Drive 324
FIGURE 9-3 Remove a Cartridge from an LTO Tape Drive 325
FIGURE 9-4 Remove a Cartridge from an SDLT Tape Drive 325
FIGURE 9-5 Manual Release Screw 328
FIGURE A-1 Base Module LTO Cells 333
FIGURE A-2 LTO Cell Locations for Firmware Site Mapping 334
FIGURE A-3 LTO Cell Locations for SCSI Element Numbering Mapping 335
FIGURE A-4 LTO Cells for Back Wall of Cartridge Expansion Module 336
FIGURE A-5 Base Module Mixed-Media Cells 338
FIGURE A-6 Mixed-Media Firmware Cell Mapping 339
FIGURE A-7 Mixed-Media SCSI Element Numbering Mapping 340
FIGURE A-8 Mixed-Media Cells for Back Wall of Cartridge Expansion Module 341
FIGURE A-9 Library and Rack Dimensions 343
FIGURE A-10 Library and Rack Clearances 344
FIGURE B-1 LTO Cartridge Components 350
FIGURE B-2 LTO Cartridge Labels 352
To Next Page
Loading...
Need help?
General
