Ordering Cartridges and Labels
96116 • Revision: KA Appendix B Cartridge Information 349
Color cartridges are approved only if the measured reflection density is greater than 0.1
as measured by an X-rite 404G color reflection densitometer. For more information
about colored cartridges, contact your Sun support representative.
Color measurements are:
Ordering Cartridges and Labels
Contact your authorized Selling Agent for Sun-branded labeled cartridges. You do not
need to order labels separately, because the data cartridges have labels already, and the
cleaning and diagnostic labels are shipped with the installation hardware. However,
you must select the VOLID range and other label options when ordering cartridges.
If you choose to order additional labels, order them from any standard media vendor.
See “Cartridge Requirements” on page 348 before ordering.
Bandwidth ANSI Status T Wide band (380 to 780 nm)
Measuring range Density (0.00 to 2.50) D
Accuracy ±0.02 D
Repeatability ±0.01 D
Aperture diameter 3.4 mm (0.13 in.)
To Next Page
Loading...
Need help?
General
