Controls and Indicators
96116 • Revision: KA Chapter 1 SL500 Introduction 11
Keypad
The keypad is used to:
â– Open the door
â– Open all CAPs
â– Notify you if service is required
Under normal conditions, at power-on, all keypad LEDs are solidly lit. Once library
applications begin:
1. All keypad LEDs turn off.
2. The Library Active LED flashes until the audit is complete, then turns off.
3. The Library Active LED turns on at the start of each command, then turns off when
each command is completed.
4. The Library Active LED flashes when the library is active.
To Next Page
Loading...
Need help?
General
