Sungrow SG8K-D - Mechanical Mounting; Installing the Inverter

User Manual 4 Mechanical Mounting
19
Hydraulic plier
Wire crimper
Crimping range:
2.5-6mm²
Wrench for MC4
terminal
Wire clipper
RJ11 crimping tool
Flat-blade screwdriver
M4
Torx screwdriver
TX30
Socket wrench
Open end:
10mm (for
M6 bolts)
13mm (for M8 bolts)
16mm (for M10 bolts)
4.4 Installing the Inverter
Inverter is installed on the wall by means of wall-mounting bracket and the
expansion plug sets.
The expansion plug set shown below is recommended for the installation. They
are not included in the delivery scope.
Stainless steel screw M6 Spring washerFender washerExpansion tube