21
1) Program unit part names
2) Program Unit Method of Use
(1) 4-Digit Displayer and 2-Digit Displayer Functions and Method of Use
A. 4-Digit Displayer and 2-Digit Displayer Functions
When you turn the power on, you will see a screen as shown in the figure.
The 4-digit displayer shows the start and end B/T sewing and the 2-digit
displayer shows the current abbreviation for the letters or numbers shown in
the 4-digit displayer (bt: the abbreviation for back tack),
<Initializing screen>
<Example of error detection>
<Example of selection of number 2 item in Group A>
The 4-digit displayer shows the error number for each type of error
discovered and also shows the programmed value after it has been
programmed. The 2-digit displayer shows the number of the parameter
specific item's content or name which is shown in the 4-digit displayer.
[ Caution ]
The 4-digit displayer and 2-digit displayer show the current condition. Therefore the user should always check it before using the
machine.
2-Digit Displayer Start B/T Selection Button
Button to Select Presser Foot-lift
Location When Machine Stops
Sunstar Logo
End B/T Selection Button Thread-trimmer and Wiper Selection
4-Digit Displayer
Button to Select Needle Plate Location When Machine Stops
Button to Change the Sewing Speed Installation
1/2 Stitch Button
Button to Save Program Changes
Button for Counter Use after Counter Programming
Pattern Work Selection Button
Pattern Work Connecting Button
Constant Sewing Speed Selection Button
Button to use Edge Sensor Selection after Edge Sensor Programming
Button for Program Change
To Next Page
Loading...
Need help?
General
