41
Save
Select the Model
Desired
Move to B-56Parameter B Group Initial Screen
Program Enable
7) Motor Controller Setting
(1) Controller Setting by Machine Type
Classification
1
2
3
SC-7300 Series
SC-7500 Series
SC-7310 Series
88
124
125
Parameters are set according to the
ordered specifications before
machine's shipment from the
factory.
Machine Type Set Value for Parameter B-56 Model Remarks
Model Number Setting
[Note]
① Before the product is shipped out from the factory, all settings are completed in line with the machine type ordered.
② In case where the controller which is different from the ordered specifications is installed to the chain-type machine:
⇨ Set the value of parameter B-56 according to the concerned machine type.
⇨ Depending on the program version of controller, it may not be applicable to some machines. See the following to make the
proper setting according to the machine type.
Version display
When the power is turned on, the CPU version is displayed as below on P/U for a moment, and then the screen moves to the initial
screen ("3333").
This is an old version where the CPU version is not displayed.
POWER ON + + or
⇨
or
⇨⇨
⇨⇨
Classification Fortuna Series III(CPU version 11) Fortuna Series IV(CPU version 11)
Program Unit
(P/U)
Handy Controller
⇨ ⇨
To Next Page
Loading...
Need help?
General
