SunStar SC9200 Series - Presser Foot Lifting Adjustment; Presser Foot Stopper Adjustment

27
21) PRESSER FOOT LIFTING ADJUSTMENT
Presser foot lifting is depending on the type of the sewing
machine. Identify the type of the sewing machine and select the
proper lifting quantity of the presser foot from the table 7.
SC(D)9300 Series
1) Loosen the nut②.
2) When lowering the presser foot lifting lever①, the backside
of the presser foot should be at the edge of the front face of
the needle plate.
To do this, move the stopper bolt③ up/down as required.
3) Tighten the nut②.
SC(D)9200 Series
1) Loosen the nut②
2) When lowering the presser foot lifting lever①, adjust the
distance(a) between the front face of the needle plate and the
back face of the presser foot.
To do this, move the stopper bolt⑪ up/down as required.
3) Tighten the nut②.
22) PRESSER FOOT STOPPER ADJUSTMENT
1) Loosen the nut⑥.
2) When lifting the presser foot, set the distance(b) between the
stopper④ and the presser foot arm⑤ at the 0mm. Adjust the
stopper④ up/down by loosening the screws ⑥, ⑦.
3) Tighten the nuts⑥, ⑦. Adjust the lifting quantity of the
presser foot on the bottom face of presser foot which is at the
center of the needle plate.
SC(D)92◇◇-◇◇/◆◇◇
SC(D)93◇◇-◇◇/◆◇◇
◆ - 2 type : ⓐ→height of presser foot 5mm
- 3 type : ⓐ→height of presser foot 5.5mm
- 4 type : ⓐ→height of presser foot 7mm
- 5 type : ⓐ→height of presser foot 8mm
[Figure 41]
[Figure 42]
[Figure 43]
①
③
②
a
⑤
⑥
④
⑦
a
b