7
SC 9200, SC 9300 Series is designed for applying sewing to knitwear and other similar
materials. Read thoroughly the following instructions.
ⓐ Read thoroughly and fully understand the manual before operating the machine.
ⓑ Dress for safety.
ⓒ Keep your hands or head away from the moving parts of the machine such as needle,
looper, spreader, take-up lever, and pulley when the machine is in operation.
ⓓ Do not remove the safety valve and all kinds of covers when the machine is in operation.
ⓔ Be sure to connect the ground wire
ⓕ Be sure the main power is turned off and the power switch is set to OFF before opening
the cover of any electrical component or control box.
ⓖ Turn the machine off when threading needles or inspecting the finished sewing.
ⓗ Do not press the pedals when you turn on the power.
ⓘ Do not drive when the cooling fan is blocked with dust. Clean the air filter in control box
once a week.
ⓙ Install the machine away from strong electromagnetic wave such as high frequency
welder as far as possible.
4) Machine Operation
Warning
Caution
[WARNING]
When you operate machine, you should put the cover on to prevent physical injury by the
belt. Turn off the power before inspecting or adjusting.
5) Saeety Device
ⓐ Safety Label : Note directions for sewing machine use
ⓑ Belt Cover : Device to prevent physical injury by the motor or clothes from being stuck
in the machine
ⓒ
Ginger Guard
: Device to prevent finger to come in contact with the needle.
ⓓ Safety Valve : Device to protect worker’s eyes.
ⓐ
ⓐ
ⓑ
ⓒ
ⓓ
To Next Page
Loading...
Need help?
General
