5-4 Publication: 0028607
WATER RECYCLING SYSTEM
5
Operating The Water Recycling
System
Engaging The Recycling System
1. Fill the debris body at least half full of water.
If you do not have half of the debris body full of
waste water, you can jet with fresh water until enough
water is reclaimed to allow the recycling system to
start.
2. Open the charge pump butterfly valve (1) located on
the passenger’s side of the truck.
Figure 5-3
3. Open the recycling butterfly valve (2) located on the
driver’s side of the truck.
Figure 5-4
4. Attach the Super Products recommended nozzle (3)
for the best performance and trouble-free operation.
Figure 5-5
5. With the truck in the working position (vacuum tube
and jet line in the sewer), activate recycling mode by
pressing ON (4) on the RECYCLE rocker switch
located on the front control panel.
Figure 5-6
To Next Page
Loading...