Super Products Camel 1200 (Ejector Unloading) - When Using Pressurized Air or Water

158 pages

Save Page as PDF

To Next Page

To Previous Page

1-4 Publication: 0028607

SAFETY

WHEN USING PRESSURIZED AIR OR WATER

Figure 1-3

When using pressurized air or water for cleaning or

material erosion/movement, you should use the following:

• Face Shield

• Wet Weather Protective Suit

• Waterproof Gloves

• Respirator

• Safety Boots with Metatarsal Guard

Main Page

Default Chapter5
- Table of Contents5
Chapter 111
- General Safety Instructions and Practices11
- Visual Attention Safety12
- Personal Protection Equipment (Ppe)13
- When Using Pressurized Air or Water14
- General Hazards and Prevention Safety15
- General Hazards and Prevention Safety - Continued16
- Crushing Hazards and Prevention Safety17
- Trip and Fall Prevention Safety18
- High-Pressure Fluid Leak Hazards19
- Power Lines/Static Electrical Hazard Warnings20
  - Overhead Power Line Tips for Construction Workers before You Begin Construction Work20
  - Working with Tools and Equipment20
- Chemical and Biological Hazard Safety21
- Transport Safety and Hazards Warnings22
- Transport Safety and Hazards Warnings - Continued23
- Job Site Safety and Hazard Warnings24
Job Site Safety and Hazard Warnings - Continued25
- Inspect the Job Site25
- Visibility Conditions When Operating25
- Prepare the Job Site25
Vacuum Equipment Operation Safety and Hazard Warnings26
- Emergency Stop Button Function26
Vacuum Equipment Operation Safety and Hazard Warnings - Continued27
- Vacuum Operation Safety27
Vacuum Equipment Operation Safety and Hazard Warnings - Continued28
- Pre-Start Checklist28
- Vacuum Operation28
Vacuum Relief Valve Safety29
- Vacuum Relief Valves29
- Operating the T-Type Vacuum Relief Valve29
Vacuum Relief Valve Safety - Continued30
- Testing the T-Type Vacuum Relief Valve30
Vacuum Relief Valve Safety - Continued31
- Operating the Remote-Operated Vacuum Relief Valve31
Vacuum Relief Valve Safety - Continued32
- Testing the Remote-Operated Vacuum Relief Valve32
High-Pressure Water Safety and Hazard Warnings - Continued34
- High Water Pressure34
Dust Hazard and Explosion Prevention Safety35
Hydrocarbon Waste Recovery36
Controlling Lower Explosive Level (LEL)36
High-Temperature Prevention37
Static Charge Dissipation38
Spark and Fire Prevention Safety39
Debris Body Dumping Safety and Hazard Warnings40
Sewer Gas Safety and Hazard Warnings41
Confined Space Hazard41
Trenching Hazards42
De-Energize and Lockout Procedures43
Hazards with Equipment Maintenance44
- Before Performing Service, Repairs, and Maintenance on the Equipment44
- Performing Service, Repairs, Lubrication, and Maintenance44
- Safety Shields, Guards, and Safety Devices Inspection44
Decal Location45
Debris Body Tailgate Props60
- Unlocking the Tailgate Props and Raising the Debris Body Tailgate60
- Lowering the Debris Body Tailgate and Storing the Props60
Preparation before Traveling to Worksite61
Chapter 263
- Introduction63
- Principles of Operation63
  - Definitions63
- Vacuum System65
- Vacuum Vent Door67
- Auxiliary Hydraulic Pump Operation72
Chapter 373
- Power Distribution Panel73
- Control System Overview75
- Cab Control Panel75
- Cab Control Panel Functions76
- Front Control Panel and Functions77
- Front Control Panel Display Screen Menu Operation79
- Curbside Control Panel85
- Pendant Functions - Wired and Wireless87
Chapter 489
- Setting the Truck at the Job Site89
- Engaging Work and Vac Modes at the Job Site89
- Purge/Prime91
- Water Pump Operation - Jetting92
  - Starting Sewer Cleaning - Typical Sequence92
- Vacuum and Boom Operation95
- Dumping Payload96
- Return to Road Mode96
- Debris Level Sensor (Option)98
- Rear Axle Overweight (Option)98
- Winterization98
- Water Lance Operation102
- Lance/Cleaning Gun Precautions103
- Hydro Excavation Kit (Option)104
  - Hydro Excavation Kit Components104
  - Hydro Excavation Kit Operation104
- Body Interconnect (Option)105
Chapter 5107
- Camel Recycling System Summary107
- Diagnostic and System Status Features107
- Typical Recycling Operation108
- The Six-Stage Separation and Filtration Process109
  - Separation109
  - Filtration109
- Operating the Water Recycling System110
  - Engaging the Recycling System110
- Filter Maintenance112
Chapter 6119
- General Information119
- Preventive Maintenance Instructions119
- DEF Maintenance120
  - Exhaust Aftertreatment Regeneration Information120
- Maintenance Schedule122
- Maintenance Items124
- Ejector Plate Slide Pad Adjustment/Replacement128
- Ejector Plate Wiper Inspection and Adjustment131
Chapter 7133
Troubleshooting Overview133
- The Basic Troubleshooting Process133
- Mechanical Troubleshooting134
- Electrical Troubleshooting141

Super Products Camel 1200 (Ejector Unloading) - When Using Pressurized Air or Water

Table of Contents