1-12 Publication: 0028607
SAFETY
1
TRANSPORT SAFETY AND HAZARDS WARNINGS
Figure 1-12
Before Transporting Truck Inspection
• Ensure unit is road worthy by performing a pre-trip
inspection before driving to and from job site.
• Check that tailgate is closed and properly locked.
• Ensure all equipment is properly secured and
positioned for maximum visibility and adequate
clearances.
• Close all water drain valves and install all plugs
and strainers previously removed.
• Check that boom (if equipped) is locked in
transport position and properly secured.
• Check that all tools, accessories, and work
tubes/hoses are properly secured.
• Check that cabinet doors and access panels are
closed.
• Check that all cleanout doors are closed and
latched shut.
• Check that the dust chute and tailgate are
closed and latched shut.
• Always measure overhead clearance height of truck
and equipment.
• Check for low hanging electric or telephone wires
and power cables on the ground.
• Look out for and avoid other personnel, machinery
and vehicles in the area. Use a spotter if you do not
have clear view.
Never Exceed your Gross Vehicle
Weight Rating (GVWR)
• In operation on public highways, the combined
weight of the chassis, body, and payload must not
exceed the gross vehicle weight rating of the chassis
as rated by the cab and chassis manufacturer.
It is possible to overload the unit capacity.
• Load your water supply at or near the job site.
• Regulate your work to maintain minimum water
storage when leaving the work location.
Pedestrian Safety
• Conduct a visual check and warning (honk horn)
before starting or moving the truck to ensure the
safety of people on the ground and other equipment
in the area.
• Be aware of all personnel who are working on the
ground.
• Look out for and avoid other personnel, machinery
and vehicles in the area. Use a spotter if you do not
have clear view.
Follow all steps before moving truck when towing
or transporting equipment to avoid serious injury
and death:
To Next Page
Loading...